MO-EL 744 Emploi Et Entretien page 7

8. Do not bring modifications to the product.
9. Keep connections dry.
10. If the power supply cord is damaged avoid to use it. Let the
Manufacturer, or the After Sale Service, or some similar qualified
person replace it, in order to avoid any risk.
11. Disconnect the appliance from the supply line, if you don't use it
for a long time.
12. Always unplug the appliance before doing any maintenance op-
eration.
13. Periodically verify the integrity of the appliance. If defects are
found, do not use it; call an Authorized After Sale Service.
14. In case of malfunction or fault, call an Authorized After Sale Ser-
vice, and request original spare parts.
This appliance is intended for indoor use only.
Installation must be carried out by a technical, qualified staff,
following the instructions supplied by the manufacturer.
Safety may be compromised by the not observing the instal-
lation directions.
An overvoltage category III bipolar circuit breaker with con-
tact opening distance of at least 3 mm must be fitted up-
stream from the supply line.
INSTALLATION
The hair dryer has been specifically designed for vertical at-
tachment on the wall.
In order to assure an additional protection, it is suggested
to install in the supply line feeding the bathroom a safety
switch with nominal differential current not higher then 30
mA. Ask to the electrician about this point.
Make sure that the wall where you plan to mount the ap-
pliance is solid and free of electrical cables or water pipes
inside.
7