Be Cool Twice Instructions page 19

R1 - Group 0 position, so that the baby can travel
fully reclining. Highly recommendable option for
the first months.
R2 - Intermediate position. (Not suitable for in the
car.)
R3 - Intermediate position. (Not suitable for in the
car.)
R4 - Group 0+ position, so that the baby can travel
seated.
Comfort for the parents:
• Pro-Fix anchorages compatible with BABYNURSE
chassis.
• Carry handle with 4 positions.
• The anchorages for the reclining position can be
bought separately for fitting in other cars.
2 Prior adjustments
Adjusting the height of the shoulder straps
To ensure the maximum protection, the shoulder
straps of the TWICE safety seat should be adjusted
just above the baby's shoulders. Check this height
with the baby correctly seated or reclining in the
safety seat.
The straps can be adjusted for length by means of
two tighteners to adapt to your baby throughout
their growing phase. Adjust both straps to the
same length.Ajuste ambos cinturones a la misma
longitud.
INSTRUCCIONES
GEBRAUCHSANWEISUNG
INSTRUÇÕES
2a - TWICE has 3 height positions for the shoulder
straps. To change height, open the rear flap and
remove the ends of the straps from the metal part
of the central tightener.
2b - Remove the straps through the front.
2c - Pull out the pieces of padding from behind and
refit them in the new slot.
2d - Reinsert the shoulder straps through the
correct slot and insert them in the metal part of the
central tightener.
2e - Check the length of the belt with the baby in
the safety seat. To do this, fasten the straps and
tighten them. Once tightened, they should hold the
baby in place without feeling tight. If you reach the
tightening limit and the straps are loose, reduce
the length of the shoulder straps.
CAUTION Check and adjust the height and length
of the shoulder straps as the baby grows.
Changing the position of the handle
The carry handle has 4 positions (Figure 2f), each of
which has a specific function:
Position 1: Horizontal position. In this position, the
handle is integrated into the shell.
Position 2: Hood gathered.
Position 3: Carry position. Position for installing
and removing the seat in a BABYNURSE chassis
and for carrying.
Position 4: AUTO position. For travelling in the car.
To change position, press the lever on the hand
grip and move the handle to the desired position.
• INSTRUCTIONS
• INSTRUCTIONS
• ISTRUZIONI
19