INTERTECHNO ITLR-2300 Mode D'emploi page 21

GB
Operating instructions
ITLR-2300(T)
How to erase codes
To erase an individual code on the receiver, proceed as in 1.) and 2.).
In this case, however, press the "OFF" button instead of the "ON" button
on the transmitter.
To erase all stored codes (reset), press and hold the learn button (L) until
the LED flashes quickly (approx. 6 sec).
Then, press the learn button (L) again briefly.
This erases all codes.
The transmitters are not required for this procedure.
Encoding with new transmitters can now commence.
To view the Declaration of Conformity, please visit
www.intertechno.at/CE