Blaupunkt KPT-R1 Mode D'emploi page 3

English
Arm/Home/Disarm
If Remote Keypad is set to Arm with Use PIN code ( * + 9 under Test Mode)
Away Arm
Home Arm
Disarm
If Remote Keypad is set to Arm without Use PIN code ( * + 8 under Test Mode)
Away Arm
Home Arm
Disarm
If Remote Keypad is set to Arm with Keypad PIN code ( * + 0 under Test Mode)
Away Arm
Home Arm
Disarm
Checking Control Panel Status
Press the Status key to inquire Control Panel status, the Status LED will light up
according to Control Panel mode.
Red LED On
Red LED Flash
Blue LED on
Dual Key Alarm Function
Dual Key Alarm function will activate alarm when both keys are pressed at the
same time. To use the functions, please enable them under Test Mode. (Default
are disabled)
1 + 3
4 + 6
7 + 9
LEDs
Active LED
The Active LED light up whenever any key is pressed.
Off
Blue LED On
Blue LED Flash
Orange LED On
Orange LED Flash
Status LED
The Status LED light up during operation or when the Status key is pressed to
inquire Control Panel status
Red LED On
Red LED Flash
Blue LED On
Blue LED Flash
1. Enter a Control Panel User PIN
Code + Arm Key.
2. Press Arm Key + put Tag on
Keypad.
1. Enter a Control Panel User PIN
Code + Home Key.
2. Press Home Key + put Tag on
Keypad.
1. Enter a Control Panel User PIN
Code + Disarm Key.
2. Press Disarm Key + put Tag on
Keypad.
Press ArmKey
Press Home Key
Enter a Control Panel User PIN Code
+ Disarm Key
Enter Keypad PIN Code + Arm Key
Enter Keypad PIN Code + Home Key
Enter Keypad PIN Code + Disarm
Key
Away Arm mode
Home Arm mode
Disarm mode
Panic Alarm
Fire Alarm
Emergency Alarm
Keypad in Standby Mode
Keypad in Normal Operation
Keypad in Normal Operation and
under Low Battery
Keypad in Test Mode
Keypad in Test Mode and under Low
Battery
Away Arm mode
Home Arm mode
Disarm mode
• No reply from Control Panel
• Incorrect PIN code
• Request for Home arm when under
Away arm mode
• Request for Force Arm
Fault LED
The Fault LED light up whenever faults are detected in the alarm system.
Orange LED On
Orange LED Off
Battery
The Remote Keypad uses one 3V lithium battery as its power source. It also
features low battery detection function to notify the Control Panel when battery
voltage is low.
When the Remote Keypad is on low battery, follow the procedure below to
change the batteries.
1. Open the back cover
2. Remove the old batteries
3. Press any key several times to fully discharge.
4. Insert the new batteries observing correct polarity.
5. Replace the back cover.
Factory Reset
If you forget your Keypad PIN code, or the Remote Keypad has any problem,
you can reset the Remote Keypad to factory default.
1. Open the back cover and remove the battery
2. Press and hold 3 key and insert battery
3. The Remote Keypad will sound 3 short beeps
4. Release 3 key, the reset process is now complete
4. Specification
Environmental Condition
-10°C to 40°C, relative humidity 85% non-condensing.
Radio
868 MHz
Alarm in memory
Fault exists in system
3