Installation And Connection; Connecting To The Power Supply; On/Off Switching - Trevi AVX 582USB Mode D'emploi Et Branchement

ENGLISH
NOTES ON USE
This is a precision electronic appliance; avoid using it in the following cases:
- Near strong heat sources, such as central heating plants or stoves.
- In very humid places such as bathrooms, swimming pools, etc.
- In very dusty places.
- In places subject to strong vibrations.
- Position the appliance in such a way that there is always enough room for free air circulation (at least 5 cm).
- Do not block the air inlets.
- If any liquid enters the appliance, unplug it immediately from the socket and take it to the nearest TREVI authorised service centre.
- Before switching on the appliance, always check that the power cable and the connection cable are properly installed.
- The apparatus shall not be exposes to dripping or splashing and that no object filled with liquids , such as vases, shall be placed on the apparatus
- Main plug is used as the disconnect device, and the main plug shall remain readily operable
CARE AND MAINTENANCE
Use a slightly damp soft cloth for cleaning. Do not use solvents and abrasive substances.
IMPORTANT
This appliance has been carefully built to ensure long-lasting perfect performance. However, should any inconvenience occur, please contact your
local authorised TREVI Service Centre.
TREVI follows a policy of ongoing research and development. Therefore products may have different features from those described.

INSTALLATION AND CONNECTION

Connect the satellite speaker cable jack (the one without controls) to the OUTPUT connector (17).

CONNECTING TO THE POWER SUPPLY

Fit the plug (18) into an AC 230V - 50Hz socket. Do not plug the appliance to different power.
Unless otherwise specified, the controls description applies to both the appliance and the remote control.

ON/OFF SWITCHING

1. Press the main POWER switch (3).
2. Press the main POWER switch again to switch the appliance off.
VOLUME, TREBLE AND BASS CONTROL
Volume, treble and bass can be adjusted using the volume knob(4), treble knob(5) and bass knob(6).
USB/SD CARD PLAYER OPERATION
PLAYBACK
1. Insert an SD memory card in the SD slot (14) or a USB device in the USB port (15).
2. Switch the appliance on, after a few seconds the player will automatically start playing the detected audio MP3 tracks.
3. Press the 4/; key (11) to pause the playback.
4. To disable the pause press the 4/; key (11) again.
5. If both an SD card and a USB device are present, the playback source can be changed using the MODE key (9), which enables switching from
SD card to USB device and to input AUX IN.
8
9
10
7
11
16
12
17
13
18
1. Satellite speaker
2. Master speaker
3. Power switch
4. Volume control
5. Treble control
6. Bass control
14
7. Power on led
8. Mp3 player led
9. MODE key to change SD/USB/AUX IN mode
10. SD correct side indication
11. 4;key, to activate playback/pause
12.  key, playback of the following track
13.
15
14. SD card slot
15. Usb device slot
16. RCA Aux In
17. Satellite speaker output
18. Power supply cord
4
AVX 582USB
key, playback of the previous track
9