Fit The Pole Saw; Extension Of The Pole Saw; Cutting Preparation - GreenWorks 1400017 Manuel D'opérateur

EN
2. Remove the chain cover.
3. Put the chain drive links (21) into the bar groove (20).
4. Put the chain cutters (22) in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (18).
8. Make sure the chain tension pin hole (19) on the guide
bar fits correctly with the bolt.
18
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
17
22
21
20
19
English
11. Tighten the chain cover knob when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
7.4

FIT THE POLE SAW

1. Mount the pole saw head on pole saw handle to achieve
the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
7.5

EXTENSION OF THE POLE SAW

1. Fit the extension pole between the pole saw handle and
the pole saw head to achieve the maximum length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
Periodically check the tightness of the connection of the
collars.
7.6

CUTTING PREPARATION

Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and protection.
• Maintain a proper grip on the machine during operation.
• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
• Never stand directly under the limb you are cutting.
8
NOTE
WARNING