Description; Overview; Safety; Installation - GreenWorks G48PS Manuel D'opérateur

1

DESCRIPTION

1.1

OVERVIEW

Figure 1-20
Small lock-out button
1
Lock-out button
2
Trigger
3
Pole saw handle
4
Collar
5
Extension pole
6
Pole saw head
7
2

SAFETY

WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

FIT THE POLE SAW

Figure 2-3
1. Mount the pole saw head on pole saw handle to achieve
the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
English
Chain cover lock nut
8
Oil tank cap
9
10 Bar
11 Chain
12 Oil indicator
13 Chain lubricant
14 Chain cover
3.3

EXTENSION OF THE POLE SAW

Figure 2-3
1. Fit the extension pole between the pole saw handle and
the pole saw head to achieve the maximum length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
Periodically check the tightness of the connection of the
collars.
3.4

USE THE SHOULDER STRAP

Figure 4
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.5

CUTTING PREPARATION

Figure 4
Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and protection.
• Maintain a proper grip on the machine during operation.
• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars during
operation.
3.6

REMOVE THE BATTERY PACK

Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.7

INSTALL THE BATTERY PACK

Figure 5
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
5
WARNING
EN