IMPORTANT SAFETY INFORMATION
• Wear protective gloves when handling, removing,
and installing drill bits. Drill bits can cut even when
stationary.
• Inspect tool before use. Replace any worn
or damaged parts. A damaged or improperly
assembled tool can malfunction, injuring nearby
personnel.
• Inspect the hydraulic hoses and couplings every
operating day. Repair or replace if leakage, crack-
ing, wear, or damage is evident. Damaged hoses
or couplings can fail, resulting in injury or property
damage.
• Use this tool for manufacturer's intended use only.
Use other than that which is described in this
manual could result in injury or property damage.
• Make sure all bystanders are clear of the work area
when handling, starting, and operating the tool.
Nearby personnel can be injured by flying parts in
the event of a tool malfunction.
Prolonged exposure to vibration or very repetitive
hand and arm movements may cause injury. Stop
using any tool if discomfort, tingling feeling, or pain
occurs. Consult a physician before resuming use of
the tool.
Greenlee Tools, Inc.
Hydraulic Rotary Impact Drill
Procedure for disconnecting hydraulic hoses, fittings
or components:
1. Move the flow lever on the hydraulic power
source to the OFF position.
2. Stop the power source.
3. Follow the sequence under Disconnecting Hoses
to prevent pressure buildup. In case some
pressure has built up, loosen hoses, fittings, or
components slowly.
Emergency stop procedure:
1. Release the trigger.
2. Shut off the hydraulic power source.
Note: Keep decals clean and legible. Replace decals
when necessary—see the decals listed in the Service
manual.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070