Charging The Appliance - Gamma Piu 025 Manuel D'utilisation Et Garantie

8 Brush for cleaning
9 AC/DC power adapter with power cable : 2.4 VDC - 800 mA (supplied)
10 Supplementary battery NI-MH (charge 2.4 VDC-800 mA) (supplied)
11 Clippers power supply socket outlet
12 Operating and charging light (blue)
13 ON/OFF Switch
14 Ring to adjust the cutting height (1.0/1.3/1.6/1.9 mm)
15 Cutting height indicator
16 Battery compartment

CHARGING THE APPLIANCE

This appliance can be used on battery power or connected directly to
the mains power supply.
USING FOR THE FIRST TIME
The appliance can only be charged with:
1) the power adaptor 9 directly connected to the appliance;
2) the power adaptor 9 directly connected to the supplementary battery 10.
• Connect the power adapter 9 (fig. A) to the power supply socket outlet 11 (fig. A)
on the bottom part of the appliance or supplementary battery 10, as illustrated
in figure B.
• Connect the power adapter plug to the socket outlet, making sure that the
appliance is off.
• Charge the appliance for 5 hours before using for the first time.
A completely charged appliance has an operating range of 50 minutes at normal
speed with the cutting height set at 1.00 mm.
When charging is complete, the blue charging LED 12 (fig. A) does not
turn off or change colour.
Do not completely discharge the battery in case you wish to use the
appliance with the power supply cable inserted.
Do not charge the appliance for longer than the recommended time;
overcharging reduces the life of the rechargeable batteries.
Before using the appliance, always ensure it is completely dry.
CHARGING AFTER THE FIRST USE
Do not charge the appliance every day.
• Ensure that the appliance is completely dry.
• Ensure that the appliance is off, or turn it OFF from the switch 13 (fig. A).
• Charge the appliance as described in the paragraph "USING FOR THE FIRST TIME. "
USE
ATTENTION! Do not use the appliance if the blade of head 2 (fig. A) is
damaged or if the blade block is not working correctly.
Do not use the appliance on wet hair.
Do not press the blade against the skin.
Do not apply the blades directly on ears or skin with imperfections
(such as swelling, injury or pimples).
TURNING THE APPLIANCE ON AND OFF
Turning on
• Move switch 13 (fig. A) to the ON position; the LED 12 (fig. A) will light up blue.
Turning off
• Move switch 13 (fig. A) to the OFF position; the LED 12 (fig. A) will go out.
USEFUL TIPS FOR CUTTING
• Wash the hair as usual, dry and brush it in the direction of growth to untangle
any knots.
• After drying, do not use hairspray, mousse or gel.
Do not recharge the appliance if the ambient temperature
is below 5°C or above 40°C.
13