Connect Button; Status Led - Gyration GC1105CKM Guide De L'utilisateur

GC1105CKM_NA_IB_REVA_K6.qxd 2/11/05
RF RECEIVER

Connect Button

Pressing the Connect button for two seconds puts the RF receiver into Connect
Mode, allowing you to synchronize a device with the receiver. If the receiver is
not manually taken out of Connect Mode, it will automatically return to Normal
Mode after one minute.
Status/Connect LED
The Status/Connect LED lights display useful information about the modes of
operation and the connection between the receiver and transmitter(s). Its
various states are:

STATUS LED

• Remains off when the receiver is operating in
Normal Mode and no devices are transmitting.
• Flickers rapidly when the receiver is operating
in Normal Mode and a synchronized device
is transmitting.
12:51 PM Page 10
CONNECT LED
• Blinks rapidly (one blink per second) when
the receiver is in Connect Mode and is
awaiting a Connect instruction from a device.
• Lights solid when connected to a device.
6
Troubleshooting
Symptom Reason
Computer does not recognize Keyboard and Receiver not
data input synchronized
Possible radio
interference
Keyboard is off
Dead batteries
Keystrokes are not consistently Possible radio
recognized interference
Solution
Perform a Connect/Connect sequence (see
Setting Up and Synchronizing the Keyboard
and the Gyration RF Receiver on page 1).
Move receiver away from other electronic
devices (e.g., monitor, speakers, radio, etc.).
Power it on (see Powering the Keyboard On
and Off on page 4).
Replace batteries
Move receiver away from other electronic
devices (e.g., monitor, speakers, radio, etc.).
7