Gyration GC1105CKM Guide De L'utilisateur page 4

GC1105CKM_NA_IB_REVA_K6.qxd 2/11/05
To set up and synchronize the Compact Keyboard and the
RF Receiver:
1. Connect the RF receiver into an available USB port and power on your
computer. Your operating system should detect the new hardware device
and initiate the installation procedure. Continue to follow the standard USB
device installation screens until installation is complete.
2. Insert four AAA batteries (included) into the keyboard.
3. Press and hold the Connect button on the receiver for two seconds, and
then release it. The Connect light will blink rapidly, indicating the receiver is
in "Connect Mode."
4. Press and release the Connect button located at the top of the keyboard.
The Connect light on the receiver will stop blinking and
remain lit.
Status Connect
LED Button
Top of
Compact Keyboard
The above illustrates the Connect/Connect sequence discussed in this guide.
12:51 PM Page 6
Connect Button
RF Receiver
2
Note: Repeat steps 3 and 4 for any additional Gyration
keyboards, and/or remotes that will be added to the system.
5. Connect Mode will automatically time out after one minute.
After the Connect/Connect sequence is performed, the receiver and device(s) will
remain synchronized after powering down. It is only necessary to perform the
Connect/Connect sequence when setting a device up for the first time or when
adding additional devices to the system.
3
® GO 2.4 GHz mice,