English; Safety Instructions; Electromagnetic Interference - MJS PULSE PRESS SOLO Serie Mode D'emploi

SAFETY INSTRUCTIONS

Read all of these instructions and save them for later reference. Follow all
warnings and instructions marked on the devices.
• These units must only be operated by qualified medical staff.
Operation of these units by any other person is entirely the
responsibility of that person.
• This manual must be read and fully understood before these units are
applied to patients.
• Equipment not suitable for use in the presence of Flammable Anesthic
mixture with air or with oxygen or nitrous oxide.
• Unplug the pumps before cleaning. Only ever use a damp cloth. Do
not spill liquid onto the pump enclosure.
• Always place pumps on a flat, stable surface before operation. The
pumps will not operate properly if tilted or at an angle.
• Do not cover the pumps whilst in operation.
• Use only the type of power source indicated on the pump's rear label.
• Do not use a damaged or frayed power cord.
• Unplug the pumps and refer servicing to qualified personnel under the
following conditions:-
o If the power cord or plug is damaged.
o If liquid has entered the pumps.
o If the plastic outer enclosure is damaged.
o If the pump is not operating normally, continuous running,
noisy running or low performance.
• Always switch off the pump before unzipping the garments.

ELECTROMAGNETIC INTERFERENCE

This equipment has been constructed and tested to comply with EN60601-1-
2 (EMC regulations for Medical devices). This test was designed to provide
reasonable protection against harmful interference. This equipment may
generate and radiate radio frequency energy and, if not installed correctly may
cause interference to radio communications. If this equipment does cause
interference then the user is encouraged to try to correct the interference by
one or more of the following measures:-
• Re-orientate or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the manufacturer of the device.
PULSEPRESS
DYNAMIC COMPRESSION THERAPY

ENGLISH