Be Cool Jupiter Mode D'emploi page 51

locked onto the ISOFIX anchor points.
2-! The load leg must be installed correctly with green
indicator.
11. Please refer to baby mode and toddler mode and
junior mode in press the release button
the base back from the seat.11.
12. Then press 12. -1 and pull back on the ISOFIX
connector -2.
12.
For transporting base, press ISOFIX release button
13.
13 -1 and move back ISOFIX connector so it is folded
completely 13. -2.
14. The car seat can be rotated 360 in order to help
to put your child into and take your child out of the
vehicle.
This also allows you change the position of the seat
-1 and pull
11.
-2.
from rearward-facing to forward-facing.
*Now you can push the rotation button 14.-2 to rotate
the seat shell towards the door and strap the child in
without difficulty.
See chapter, "SECURING BY MEANS OF HARNESS
SYSTEM. "
Shell be locked in place with an audiable "clik"
NOTE! Before starting your journey you must return
the seat shell to a defined locked position by pressing
the position adjustment handle.
NOTE! Avoid getting any dirt or sand in between the
upper seat shell 14.-1 and the base 14.-2 .This can
have a negative impact on the performance of the
rotation and recline function.should this happen the
dirt should be removed before rotating and reclining
EN
51