DeWalt DW0165 Manuel D'utilisation page 20

Press
2.
E
on and display the red laser dot.
Make sure the tool position setting
3.
(Figure
C 4
measurement.
Select as the measurement type.
4.
• Press
(Figure
E 2
• Press
• Press
Type Menu (Figure
• Press the arrow buttons to select
(Figure
E 4
• Press
Point the laser at the highest point of the
5.
building, wall, or object (Figure
Press
6.
On the bottom line of the screen, view the
7.
height of the building or object (Figure
).
S 2
Measuring from a Tripod
If you are placing the tool on a tripod to
measure the height of a tall building, follow
these steps (Figure
Screw the 1/4-20" hole on the back of the
1.
tool onto the 1/4-20" connection on the top
of your tripod (Figure
Point the tool's laser (Figure
2.
a wall or object, and not toward anyone's
eyes.
Press
3.
on and display the red laser dot.
Make sure the tool position setting (Figure
4.
) is to measure from the tripod
C 4
connection.
20
(Figure ) to turn the tool
A 3
) is correct for taking the
to display the Main Menu
).
to select .
to display the Measurement
).
E 3
).
.
S 1
to take the measurement.
).
T
).
T 1
A 1
(Figure ) to turn the tool
A 3
Select
5.
• Press
(Figure
• Press
• Press
Type Menu (Figure
• Press the arrow buttons to select
(Figure
• Press
Point the laser at the lowest point of the
6.
wall or object whose height you need to
measure (Figure
Press
7.
Point the laser at other points on the wall
8.
or object (Figure
).
When ready, press
9.
measurement.
On the bottom line of the screen, view the
10.
height of the wall or object (Figure
Positioning Studs
When you are framing a wall, use the
Stakeout feature to easily mark the position
of each stud (Figure
Point the tool's laser (Figure
1.
a wall or object, and not toward anyone's
eyes.
Press
2.
) toward
on and display the red laser dot.
Make sure the tool position setting (Figure
3.
C 4
back of the tool.
as the measurement type.
to display the Main Menu
).
E 2
to select .
to display the Measurement
E 3
).
E 4
.
).
T 2
to take the measurement.
).
T 3
to take the
a
a
).
U
(Figure ) to turn the tool
A 3
) is set to to measure from the
).
).
T 4
) toward
A 1