Bematech SB-8200 Guide De Démarrage page 16

- The video monitor should be place strategically so that the lights of the room do not reflect the operator,
disturbing the correct visibility of the screen;
- As a safety measure, it is advised the use of a voltage stabilizer or UPS between the equipment and the line
socket;
- Install the equipment away from sun rays, vapor, gases, smoke, humidity and suspended particles;
- Read the limitations of the warranty manual before installing the equipment.
Connecting to the electrical network
Check that the Smart Box is unplugged, if it is, connect it to the line power. Watch that the socket should have
three holes for its correct ground connection.
It is important to check that the voltage selector is in the position corresponding to the electrical provision.
Special care
Check carefully the electrical tension before connecting the Smart Box equipment.
You should take special care with the tension and the maximum voltage the equipment supports. In case of
doubt and/or adjustment of the socket, ask a professional. You should take the same care if you have to install
an extension wire, a voltage stabilizer or UPS. The user is exclusively responsible for taking these precaution
measures, being them essential for the effect of the warranty coverage.
The Smart Box purchased has been manufactured under international safety standards that protect the user
against electrical shocks in case electrical network failure or accident. For this protection to work properly, it
is essential that equipment be connected to a three-hole socket connected to the ground.
Only connect a peripheral or accessory to your system when it is disconnected.
Store all the material used in the Smart Box equipment package; these are the most appropriate to transport
the equipment in case of moving its location.
Before cleaning the equipment, make sure it is disconnected from the electrical network. Use just a wet cloth
to clean it. Do not use detergents, abrasive or solvent products.
Do not try to repair the equipment by yourself, nor allow any unauthorized person to do it. There is risk of
electrical shock, even with the wire disconnected from the electrical network. Contact the Bematech S.A.
Service centers whenever necessary.
16