Site Selection And Preparation - RealFlame 1360E Mode D'emploi

SITE SELECTION AND PREPARATION

To reduce the risk of fire or electric shock when installing:
• Make sure the power cord is not pinched or against a sharp edge when installed.
• Ensure that the power cord is stored or secured to avoid tripping or snagging.
• Construction and electrical outlet wiring must comply with local building codes
and other applicable regulations.
• Do not attempt to wire your own new outlets or circuits. Always call a licensed
electrician.
See figure 1 for grounding instruction.
This heater is for use on 120 volts.
The cord has a plug as shown at A in
Figure 1. An adapter as shown at C is
available for connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
Manual Reset
To manually reset the firebox, unplug power cord, wait 15 seconds and plug back into
the wall outlet.
WARNING
GROUNDING PIN
GROUNDING
MEANS
NOTE: This adapter is
prohibited in Canada.
5
COVER OF GROUNDED
OUTLET BOX
METAL SCREW
NOTE: This adapter is
prohibited in Canada.
*ADAPTER
GROUNDING PIN
Fig. 1