Motion Detection - Blaupunkt BP 3.0 FHD GPS Manuel D'utilisation

XIII.Motion Detection
In standby mode, press MENU key to enter into setting in Movie Mode and select 'Motion
Event REC' to choose recording time of every movie clip in motion detection.
After confirmation, press OK key to quit 'Motion Event REC' and then press MODE key to go
to General Settings. Select 'Motion detection' and press OK key to select the sensitivity.
Here are 3 steps sensitivity, 'High' , Middle' and 'Low' . Middle is suggested when motion
detection turning on. Press OK key to confirm and then press MENU key to quit. DVR starts
to automatically countdown from 9 second to activate motion detection. If there is any
movement detected, DVR will record automatically in preseted recording time of movie
clip. In motion detection mode, press any key to quit and go back to standby mode. Press
MODE key 4 times can go back to mode detection mode again.
To turn off motion detection, please go to General Settings.
Movie Mode
Movie Off Time
Motion Event REC
2/3
Sound Record
UP MENU OK
P
STBY
BP 3.0 FHD GPS 0 KM/H
2015/09/08 15:12:45
UP MENU OK
5sec
1min
On
MODE DOWN
EV:0.00
ACD 1010
0:01:44
MODE DOWN
General Settings
Protect Level
Parking Monitoring
4/6

Motion Detection

UP MENU
Motion Detection Icon
Middle
Off
Middle
OK MODE DOWN
11