Blaupunkt BP 3.0 FHD GPS Manuel D'utilisation page 13

X.Parking Monitoring
Enter into General Setting to turn on parking monitoring function and there are three-step
settings(High, Middle and Low).Middle is suggested when parking monitoring turning on.
When parking monitoring is at work, DVR will show 'P' on the top left.
A. After the car engines off, DVR will be automatically power off too, but once DVR detects
vibration, it will power on automatically and record 10 seconds and then turn off again. If
other functions are working at same time,parking monitoring is top priority.
B.When parking monitoring turning on while driving, DVR will power on automatically
once it detects vibration and record circlely with the first file locked.
Note: Saved file will be saved until users delete from micro SD card.
Go to General Setting to turn off parking monitoring and 'P' will disappear.
General Settings
Protect Level
Parking Monitoring
4/6
Motion Detection
UP MENU
XI.GPS Tracking
This DVR is built in GPS module and can record the driving track, longitude and latitude
information as well as real-time speed, which are very important driving information.
When DVR is on, it will position automatically. There is GPS status icon on the top left.
When it turns green, GPS positions successfully; when it is red, GPS is still in positioning
status. Please go to GPS status in Gerneral Settings to view detailed GPS information.
Please select correct time zone before use this function. Please enter into General Settings
to set it up. After GPS positions successfully, GPS satellite time will synchronize to show on
the screen.
Note: Please position outdoor. GPS is hard to position indoor because of weak GPS signal.
Driving track can be reviewed with exclusive GPS player. Please refer to 'Part 7 BP GPS VP
3.0 Instruction' .
High
Middle
Off
OK MODE DOWN
Parking Monitoring ON
P
BP 3.0 FHD GPS
2015/09/08 15:12:45
UP MENU
REC
EV:0.00
0 KM/H ACD 1010
0:01:44
OK MODE DOWN
9