Operation; Problem Chart; Replacing The Crossfader - Omnitronic EX-840 Mode D'emploi

6. OPERATION

Switch the device on via the power switch.
As soon as the Audio-signals are present the signal level is displayed. You can adjust the level of the input
signals via the Gain-control.

7. PROBLEM CHART

PROBLEM:
No power.
No sound.
Noise.
While you are changing the
crossfader assignment, the
master-output cuts off.
The desired channels
cannot be synchronized.

8. REPLACING THE CROSSFADER

Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.
All manuals and user guides at all-guides.com
CAUSE:
• The power-cord is not connected.
• The PHONO/LINE/AUX-switch of the
respective channel is in the wrong
position.
• The power-cord of the respective
device is not connected properly or
not connected at all.
• The connection-socket or the plug is
dirty.
• The input-signal is too strong.
The assignment of both Channel
Assign-selectors overlaps.
The wrong channels have been
selected with the Channel Assign-
selectors.
26/47
REMEDY:
• Check the power-cord and any
extension-cables.
• Put the PHONO/LINE/AUX-switch
into the correct position.
• Check the power-cord and if the
plugs are tightly connected with the
sockets.
• Clean the socket and/or the plug.
• Reduce the input-signal via the Gain-
control.
Switch the crossfader off with one of
the Channel Assign-selectors before
you change the assignment.
Select the correct channels.
10007050_V_1_1.DOC