Omnitronic EX-840 Mode D'emploi page 24

(10) FADERSTART-BUTTON
Press this button to activate the faderstart.
(11) CROSSFADER
Mixes the signals of one channel with another. If the crossfader is in the center-position, both channels
can be heard at the same volume.
(12) MIC 1-SOCKET
You can connect microphones with XLR-plug or jack.
(13) TREBLE-CONTROL
Used to increase or lower the HIs of the microphone signal.
(14) MIDDLE-CONTROL
Used to increase or lower the MIDs of the microphone signal.
(15) BASS-CONTROL
Used to increase or lower the LOWs of the microphone signal.
(16) TALKOVER-SELECTOR
The TALKOVER-selector has 3 different functions:
OFF: the microphone is switched off.
MIC ON: the microphone is activated.
TALKOVER: the level of all other signal-sources is attenuated by 14 dB, so that the microphone can
clearly be heard.
(17) MIC 1 VOLUME-CONTROL
With the MIC 1 VOLUME-control, you can adjust the mic 1 volume.
(18) MIC 2 VOLUME-CONTROL
With the MIC 2 VOLUME-control, you can adjust the mic 2 volume.
(19) MASTERFADER
Adjusts the level of the master 1 output.
(20) ZONE VOLUME CONTROL
The EX-840 features a DJ BOOTH monitor system. Connect your monitor system with the BOOTH-
sockets on the rearpanel.
(21) BALANCE-CONTROL
Used to adjust how much of the signal is sent to the left and right MASTER-socket.
(22) MONO/STEREO SWITCH
Used to set the master output to mono or stereo. If you connected a mono-signal via 1 RCA-socket, you
can switch the output signal to STEREO in order to have a stereo output signal.
(23) MASTER LEVEL / CUE LEVEL DISPLAY
The lower display shows the level of the left and right master output.
The upper display shows the level of the channel currently being cued (CUE LED on).
(24) POWER SWITCH
Press this button to start operation.
(25) PARAMETER TIME-CONTROL
With the Parameter Time-control, you can adjust the effect time.
(26) PARAMETER RATIO-CONTROL
With the Parameter Ratio-control, you can adjust the effect ratio.
(27) INPUT SELECTOR
For selecting the desired source.
(28) EFFECTS SELECTOR
For selecting the desired effect.
(29) EFFECTS DISPLAY
(30) BEAT SYNC-BUTTONS
Via the Beat Synch-buttons, you can adjust the effects to the current track's beat.
(31) X-FADER EFFECTS-BUTTONS
(32) EFFECTS CUE-BUTTON
Use the Effects-Cue-button in order to monitor the effects.
(33) EFFECTS ON/OFF-BUTTON
Use the Effects On/Off-button in order to switch the effects on and off.
(34) TAP-BUTTON
Via the Tap-button, you can display the beats per minute of a track. Press the button in the rhythm of the
music. The display shows the current beats per minute (BPM).
(35) BOOTH-CONTROL
The EX-840 features a DJ BOOTH monitor system. Connect your monitor system with the BOOTH-
sockets on the rearpanel.
(36) CUE MIXING FADER
Connect your headphones to the HEADPHONES socket. With the CUE-buttons, you can select the
desired channel.
All manuals and user guides at all-guides.com
24/47 10007050_V_1_1.DOC