Audio-Technica ATM350a Manuel De L'utilisateur page 12

AT8491G
Guitar mount
1.
2.
• Rotate the screw and adjust the length, and then
tighten the screw to secure in place.
• To prevent damage to the instrument, take care not to
tighten the screw excessively.
AT8491S
Surface mount
• When using the grill fastening screw on the accordion
Depending on the shape of the screw, it may not be
possible to install in this way.
1.
1
2
1
4
3
3
2
2.
• Affix the adhesive silicon pad to the back side of the
mount. Loosen the grill fastening screw on the
accordion, insert the mount, and then tighten the grill
fastening screw to secure in place.
AT8491S
Surface mount
• When using surface fasteners
• Affix the transparent protective film (①) to the body of
the instrument, and affix a surface fastener tape pad
(②) on top of that. Also affix a mount fastener tape pad
(③) to the back side of the mount, and then affix it to
the surface fastener on the body of the instrument to
secure in place.
• Affix the transparent protective film on a clean, flat
surface so that air bubbles do not form.
• You cannot affix the transparent protective film on
unfinished wooden parts.
• To stabilize the adhesive strength of the adhesive sides
of the surface and mount fasteners (②, ③), let them sit
for about a day after affixing them before using the
mount.
5
4
2
1
3