europool NeoPAC Serie Manuel D'instructions page 41

NeoPAC
• Start the pool pump
• Turn on the pool heat pump with the on/off switch (turn it to « I »).
• Check the machine to make sure that it starts only together with the filtration pump: If the
filtration pump is not working, the controller will shows "FLO". If it doesn't detect the water flow,
please see chapter « water flow switch setting ».
• The pool heat pump will work after a delay of few minutes.
• Set regulation (Chapter «Regulation»).
• Set heating (Chapter «Heating»).
After a few minutes (time for circuit to heat itself) you can regulate water flow as explained
hereafter (Chapter "Water flow regulation")
After these operations, you must put your pool cover on the swimming pool and let the heat
pump work for few days in order for the water temperature to increase to the desired
temperature.
- 41 -