How To Clean The Appliance - EDM Product 07652 Mode D'emploi

INSTRUCCIONES IMPORTANTES DE SEGURIDAD
07652
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
8. Unplug the socket.

HOW TO CLEAN THE APPLIANCE

- Before cleaning the coffee maker, be sure to unplug the appliance from the outlet
and make sure it is cold.
- Do not immerse the power cord, plug, or appliance in water.
- When the coffee maker has completely cooled down, clean the exterior with a soft,
slightly damp cloth; do not use aggressive products.
- Clean the permanent filter (if applicable) and other removable components in hot
soapy water, rinse with cold water and dry them before putting them back in place.
- Clean the inside of the jar with a soft brush and hot soapy water. Rinse it with cold
water and dry it before using it again. Note: Do not wash the jar in the dishwasher.
- Clean the appliance at least once every 3 months to maintain optimum performan-
ce.
- Store the coffee maker in a dry place where it is not very hot.
DECALCIFICATION
You must descale the appliance periodically, otherwise the taste of the coffee will be
bad and the lime deposited inside the coffee maker can cause permanent and
irreparable damage to the machine.
If you notice an increase in noise during boiling, the coffee maker takes longer to
prepare the coffee or the appliance turns off before the water tank empties, it may
be due to the need for descaling.
The frequency depends on the hardness of the water and the frequency with which
you prepare coffee.
In general, you must decalcify with the following frequency:
- With soft water, a minimum of once every three months.
- With hard water, a minimum of once a month.
If you do not know what the hardness of your water is, check this with your local
water company.
We recommend that you use a specific liquid softener for coffee machines and that
you carefully read the instructions on its packaging or in the user manual before
using it.
1. Mix the appropriate amount of softener with cold water in a measuring jug. Note:
do not use powder softener.
2. Fill the water tank to the maximum level with the prepared solution.
3. Start the coffee maker and allow the water tank to drain completely as if you were
brewing coffee, but without a paper filter or ground coffee in the filter holder.
4. Repeat steps 1 to 3 to perform another disqualification cycle.
Note: do not fill the water tank with the descaling solution already used because it
will not have the same effects.
5. Let the coffee maker run two more cycles with cold water to remove all residues of
the descaling solution.
Important:
a) Do not interrupt the descaling process.
b) The guarantee does not cover the malfunction of the appliance caused by lime