Detergents And Additives - Electrolux ARTHUR MARTIN AWT 6020 W Notice D'utilisation

Problems
The appliance vibrates, is
noisy:
The wash cycle is much
too long:
The washing machine
stops during a wash cy-
cle:
The lid doesn't open at
the end of the cycle:
The "Start/Pause" push-
2)
button flashes red
The "Start/Pause" push-
2)
button flashes red
The "Start/Pause" push-
2)
button flashes red
Softener runs directly into
the drum when filling the
dispenser box:
1) Depending on model.
2) On some models, the auditable signals can sound
3) After solving any problems, press "Start/Pause" pushbutton to restart the interrupted programme.

Detergents and Additives

Only use detergents and additives designed for
use in a washing machine. We do not recommend
mixing different types of detergents. This may spoil
the washing. There are no restrictions on the use
of powder detergents. Liquid detergents must not
• all packaging have not been removed from the appliance (see installation
section),
• the appliance isn't level and is unbalanced,
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum,
• the load is too small.
• the water inlet filters are dirty,
• the power or water supply has been cut off,
• the motor overheating detector has been activated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been activated (too much de-
tergent) and the washing machine has begun draining the foam,
• the out of balance detector has been activated: an extra phase has been
added to distribute washing more evenly in the drum.
• the water or electricity supply is defective,
• a Rinse hold has been selected,
• the drum shutters are open.
• the "immediate opening"
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the cycle
• the lid is not closed properly.
3)
:
• the drainage filter is obstructed,
3)
• the drain hose is blocked or bent,
:
• the drain hose is fixed to high (see "Installation" section),
• the drainage pump is blocked,
• the standpipes blocked.
• the water tap is closed,
3)
• the water supply has been cut off.
:
• you have gone past the MAX indicator.
Causes
1)
light is not lit,
be used when a prewash has been selected. For
cycles without prewash, they must be added via
means of a dosing ball. Detergent tablets or doses
must be placed in the detergent compartment of
your appliance's dispenser box.
electrolux 15
3) 1)
.