Electrical Safety; Assembly; Before Use - B+BTec Diamond3 professional MX11 Manuel D'utilisation

GB
− repair work
− maintenance- and cleaning work
− eliminating faults
− checking tangled or damaged
cables
− transport
− unusual sounds or vibrations
• Maintain your machine with care:
− make sure the ventilation openings
are clean.
− make sure the grips are free of
grease and oil.
• Check the machine for possible
damage
− Before use check all safety devices.
Make sure they are installed cor-
rectly and function properly.
− Check the machine for damaged
parts. All parts must be mounted
correctly to ensure proper function-
ing of the machine.
− Damaged protective devices
and parts should be repaired or
replaced by an authorized serice
center.
− Damaged or illegible safety stickers
should be replaced.
• Store your machine in a dry, locked
space out of reach of children.

ELECTRICAL SAFETY

• The cable should comply with IEC
60245 (H 07 RN-F) and should have
a diameter of at least:
3 x 1,5 mm² for lengths up to 25 m.
3 x 2,5 mm² for lengths over 25 m.
• The use of long or too thin cables will
result in a loss of power. The perfor-
mance of the motor will be reduced.
• Plugs and sockets should be made out
of rubber, PVC or another thermoplas-
tic material with the same density or be
coated with such a material.
• Electrical connections should be splash
water proof.
DIAMOND3
• Prevent cables and extension cords
• Completely unwind cable drums.
• Check extension cords for dam-
• Do not use damaged cables.
• Do not use improvised connections.
• Do not bypass or deactivate protective
• devices.
machine should always be carried out by
certified electricians or an authorized ser-
vice center.
should be carried out by the manufacturer
or an authorized service center.
of other parts may lead to damage to the
machine or injuries to the operator.

ASSEMBLY

Mounting of the whisk: Screw the whisk
(2) onto the spindle (8). Secure the whisk
using the wrenches.

BEFORE USE

• Check if the machine has been assem-
• Before use check:
16
MX11
®
from getting tangled, stuck or bent and
make sure connections do not get wet.
age regularly and replace when
neccessary.
Repairs to electrical parts of the
Repairs to other parts of the machine
Use original spare parts only. The use
bled completely and according to the
instructions.
− if any of the cables is damaged
(rips, cuts) Never use damaged
cables.
− if the machine is damaged (see
safety instructions)
− if the whisk is mounted correctly