Breville Diecast Smart Manuel D'instructions page 7

OPERATING PAGE HEADER.....
BAGEL BUTTON
This feature activates additional heat to
the middle heating elements to perfectly
toast the insides of your cut bagel without
burning the outside.
To toast bagels:
Place the cut bagel into the toasting
1.
slots with the inside of the bagel facing
inwards as per the bagel markings above
the middle heating elements of the
toaster.
Select the desired browning setting by
2.
adjusting the browning control slide on
the front of the toaster. There are
12 browning settings ranging from
'1' (lightest) to '5' (darkest).
To select the BAGEL setting, press
3.
the BAGEL button and the button
surround will illuminate white. To
start the toasting process, press
the TOAST|CANCEL button which
will illuminate red. The bagels will
automatically lower into the toasting
slots. The middle and side heating
elements will automatically adjust.
NOTE
It is normal for the outside heating
elements to appear off or on a lower
power during the bagel setting. This
ensures the inside of your cut bagel
toasts without burning the outside.
After the cycle has finished, press the
4.
BAGEL button to deselect the setting.
12
FROZEN BUTTON
This feature activates additional toasting
time required to defrost then toast
frozen bread.
To toast frozen bread:
Place the bread into the toasting slots.
1.
Select the desired browning setting
2.
by adjusting the browning control slide
on the front of the toaster. There are
12 browning settings ranging from
'1' (lightest) to '5' (darkest).
To select the FROZEN setting,
3.
press the FROZEN button and the
button surround will illuminate
white. To start the toasting process,
press the TOAST|CANCEL button
which will illuminate red. The bread
will automatically lower into the
toasting slots. The toasting time will
automatically increase.
After the cycle has finished, press
4.
the FROZEN button to deselect
the setting.
PAGE HEADER..... OPERATING
LIFT & LOOK ‰ BUTTON
This feature automatically raises and lowers
the carriage so you can check the toasting
progress without interrupting and/or
cancelling the toasting cycle.
To select this feature:
‰
The LIFT & LOOK button surround
1.
will illuminate white during the toasting
cycle and when using the
‰
A BIT MORE , BAGEL and FROZEN
features. You can press the
‰
LIFT & LOOK button during the
toasting cycle to view the toasting
progress. If selected, the LIFT & LOOK
button surround will flash. The LED
toasting progress indicator will cease
to flash indicating that the selected
toasting cycle time has not been
‰
interrupted. When the LIFT & LOOK
cycle has finished, the toasting cycle will
re-commence, indicated by the resumed
flashing of the LED toasting progress
indicator.
NOTE
Toasting can be stopped at any time,
even during the LIFT & LOOK ‰ cycle,
by pressing the TOAST|CANCEL
button. This will cancel the operation
and the carriage will move to the raised
position.
Approximately 10 seconds before the
2.
end of the selected browning setting,
‰
the LIFT & LOOK button will cease
illumination and cannot be activated
during this time.
TOAST READY ALERT
A toast ready alert will sound when the
toasting cycle has finished and the carriage
has risen and locked into the raised position.
The default volume setting for the toast ready
alert is 'High' but can be adjusted to 'Low' or
'Mute'.
Adjusting the volume of the Toast
Ready Alert
Press and hold down the LIFT & LOOK
button for 2 seconds until the A BIT MORE
BAGEL & FROZEN buttons illuminate white.
While these buttons are illuminated, adjust
the volume as follows:
‰
Mute:
Press the FROZEN button. The button
surround light will flash three times.
Low:
Press the BAGEL button. The toaster will
beep three times with low volume.
High:
Press the A BIT MORE ‰ button. The toaster
will beep three times with high volume.
‰
‰
,
13