Programmed Play - Aiwa CA-DW257 Mode D'emploi

REPEAT /
OSC / SLEEP
POWER/
6 STANDBY/
TAPE,
RADIO, CD
A
CD OPERATION
1
Press CD.
The power is turned on and the CD indicator lights up.
2
Press PUSH OPEN to open the disc
compartment. Place a disc with the printed
side up and close the disc compartment.
Total number of tracks and total playing time are
displayed. It will take about 15 seconds when loading a
CD-RW disc.
3
Press *A PLAY/PAUSE to start play.
The number of the track being played and elapsed
playing time are displayed.
* or c PLAY on the remote control
s STOP/MEMORY – Stops play.
*A PLAY/PAUSE – Pauses play. To resume play,
press again.
* or a PAUSE on the remote control
r,t SKIP/SEARCH – Searches for a particular point
during playback. Keep r or t pressed and then
release it.
– Skips to the beginning of a track. Press r or t
repeatedly.
*REPEAT/OSC/SLEEP
– Repeats a single track or all tracks. Select as follows.
[ 1: A single track is played repeatedly.
Select a track with r or t.
[: All tracks are played repeatedly.
* or REPEAT on the remote control
To start play when the power is off, press CD. The
power is turned on and play of the loaded disc begins
(Direct Play Function).
If you load a disc while the CD indicator flashes in step 2,
play starts without pressing A.
To select a track directly with the remote control, press
the numbered buttons 0-9 and +10. CD play starts from the
selected track and continues to the last track.
Example:
To select number 25, press +10, +10 and 5.
To select number 10, press +10 and 0.
4
ENGLISH
A
After listening, press POWER/6 STANDBY to turn the
power off.
NOTE
• Do not use irregular shape CDs (example: heart-shaped,
octagonal ones).
It may result in malfunctions.
• Do not place more than one disc in the disc
PUSH OPEN
compartment.
• Do not try to open the disc compartment during play.
• Do not touch the lens. Doing so may cause malfunctions.

PROGRAMMED PLAY

Up to 30 tracks can be programmed from the disc.
1
In stop mode, keep *s STOP/MEMORY
pressed until "M" flashes in the display.
* or s on the remote control
2
Press r or t to select a track, then press
s STOP/MEMORY to store it.
To select a track with the remote control
Press the numbered buttons 0-9 and +10.
3
Repeat step 2 to program other tracks.
To return to stop mode in steps 1 to 3, keep s pressed.
4
Press A to start play.
To check the program, press r or t in stop mode.
To clear the program, press s once in stop mode so that
"M" disappears in the display.
To change the programmed tracks, clear the program and
repeat all the steps again.
B
PLAY/PAUSE
SKIP/SEARCH
STOP/MEMORY
LW
Track number
Programmed number
TUNING
MW FM MONO
FM STEREO
BAND