Solving Problems - Graco Family Listen 'n Talk Plus 2780 Manuel D'utilisateur

To Speak to Baby and Parent
• Turn on Nursery Unit using the Volume ON/OFF switch.
• Turn on one or both Parent Units using the Volume ON/OFF switch.
• On one Parent's Unit, press and hold BOTH Push-To-Talk-Baby "B" AND Push-To-Talk-Parent
"A" buttons. Parent's Unit is ready to transmit when green power light blinks once. (If green
light does not blink, you will not transmit to Nursery Unit or Parent's Unit. Refer to Solving
Problems on this page.)
• Speak into Parent's Unit holding unit 12"-24" from your mouth. Holding unit closer will cause
the sound to be distorted.
• Release button when finished speaking.
NOTE: When one Parent's Unit is speaking to the Nursery Unit and to the other Parent's Unit,
neither Parent Unit will receive from the Nursery Unit. The receiving Parent's Unit will not be
able to transmit to the Nursery Unit or the other Parent's Unit.

Solving Problems

DO NOT ATTEMPT TO MODIFY THE UNIT.
Any modifications to the transmitter and/or receiver can
void the operator's authority to operate the equipment.
Most problems have a simple solution.
First, check that:
• Power is turned ON for both units
• Both units are plugged in (or battery is fresh in Parent's Unit)
• Electrical outlet works
• Units are set to same channel (see page 7)
• Volume is turned up on Parent's Unit
• Parent's Unit is in range of the Nursery Unit
906-2-02
10