Connecting The Inlet Hose - Samsung DV435 Serie Mode D'emploi

CONNECTING THE INLET HOSE

Method 1
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
1. If space permits, attach the brass female end of the "Y"
connector to the cold water faucet.
2. Turn the cold water faucet off .
3. Attach the straight end of long hose to the "Y' connector.
4. Using pliers, tighten the coupling with an additional two-
thirds turn.
5. Attach the angled end of long hoses to fi ll the valve at the
bottom of the dryer's rear frame. Screw on the coupling by
hand until it is seated on the fi ll valve connector.
6. Using the pliers, tighten the coupling with an additional two-
thirds turn.
7. Check that the water faucets are on.
8. Check for leaks around the "Y" connector, faucets and
hoses.
DV435-02836G-02_EN_20121123.indd 19 DV435-02836G-02_EN_20121123.indd 19
Do not overtighten, as this may damage the coupling.
Do not overtighten, as this may damage the coupling.
Y-Connector
Water Hose
Duct Exhaust
Frame
(back)
Water Hose
Installing your dryer _19
2012-11-23 2012-11-23 5:03:32 5:03:32