SCANMASKIN 32 WORLD Serie Manuel page 96

Every 500 hours
For more detailed
information about
the 500-hour service
interwall check the
Service Manual
Every 500 hours
For more detailed
information about
the 500-hour service
interwall check the
Service Manual
Every 1000 hours
For more detailed
information about the
1000-hour service
interwall check the
Service Manual
96
This service is recommended to be per-
formed by Scanmaskin authorized work-
shop
 Change the v-ring seals that is fitted on the
grinding heads upper side. (570136)
 Change the rubber damper that is located on
each grinding head.
(910093)
 Open up the machine house and inspect main
radial seal (580312)
No dust should be inside the machine house.
 Check the main belt for wear.
 Check tension on the belt
 Clean and lubricate the gears and gear ring
inside the machine house.
Only use approved grease from Scanmaskin.
(570100) Note this grease is only for trans-
missions and not for seals.
Before closing the machine house, make
sure to lubricate the radial seal and the sur-
face where the radial seal is working against
with grease. Use regular grease type NLGI 2
This service is recommended to be per-
formed by Scanmaskin authorized work-
shop.
 Remove the grinding heads and change the
three radial seals (580334) that protects the
bearings. Clean and lubricate with grease be-
fore installing new ones. Use regular grease
type NLGI 2
 Change the main radial seal
(580312)
Before closing the machine house, make
sure to lubricate the radial seal and the sur-
face where the radial seal is working against
with grease. Use regular grease type NLGI 2
www.scanmaskin.com