Using The Led Light; To Start A Vehicle; Starting Attempt - Stanley SXAE00125 Instructions D'utilisation

2.4. Using the LED light

1. Slide the ON/OFF switch to the ON position.
2. Hold down the power button for 3 seconds.
3. Once the LED light is on, press and release the power button to cycle through the following
modes:
 Steady glow
 Flash for an SOS signal
 Flash in strobe mode
4. When finished using the LED light, press and hold the power button until the light turns off.
5. Slide the ON/OFF switch to the OFF position.
6. Recharge the unit as soon as possible after each use.
3. Instructions manual

3.1. To start a vehicle

IMPORTANT:
 Do not use the booster while charging its internal battery.
 Using the booster without a battery installed in the vehicle will damage the vehicle's electrical
system.
 Only jump start a 12V lead-acid battery system vehicle.
 Only use the smart cable SXAE00140 for the jump start function.
NOTE: The internal battery must have a charge if at least 40% to jump start a vehicle.
Turn OFF ignition and all electrical devices (heating, lighting...) before using the booster.
Lay the DC cables away from any fan blades, belts, pulleys and other moving parts.
1. Connection to the booster - Stand-by mode
Plug the battery clamp smart cable into the booster's output socket. The green LED is flashing on the
smart cable, which means that the booster is in "Jump Start Stand-by mode".
2. Connection to the battery
Check first if the negative terminal is connected/grounded to the chassis. If not, contact your reseller.
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the black clamp (-)
to the earth/chassis of the vehicle (a heavy gauge metal part of the frame or engine block. Do not
connect to the carburetor or fuel lines).
3. Jump Start mode
The green LED on the smart cable turn into solid green, which means that the booster is in "Ready
to Jump Start mode".
NOTE: Once the LED light is green (solid), you will have 120 seconds to jump start the vehicle.
Otherwise, you need to restart the booster procedure back to step 1.
NOTE: If the vehicle battery is extremely discharged, the initial current draw from the booster may
activate short circuit protection in the smart cable. When the condition is corrected, the smart cable
will automatically reset.
4. Start the engine
Crank the engine for maximum 3 seconds and wait at least 1 minute before a second attempt.
5. Disconnect the output lead
After the engine starts, unplug the battery clamps from the booster socket.
6. Disconnection
Disconnect first the black clamp (-) and then the red clamp (+).

3.2. Starting attempt

When using the booster to start an engine, do not crank for more than 3 seconds, and wait
at least 1 minute before a second attempt.
5