Blue Hawk SGY-NR-KITC Mode D'emploi page 17

Ensemble de cloueuses 4 pièces pour la finition, les moulures et les décorations
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
4. Air supply
When connecting air supply, always keep hands and body away from discharge area of tool.
A filter regulator-lubrication (not included) is required and should be located as close to the
tool as possible.
Make sure the air pressure is set at the correct range of 60 - 100 PSI before using. Never
exceed 110 PSI.
4
Quick
Connector
Tool
5. Loading fasteners and operating
Insert a strip of fasteners into magazine, keeping it pointed down.
Release the latch and pusher. Slide the pusher against the nails.
Never operate tool unless safety nose is in contact with workpiece. Do not operate tool
without fasteners or damage to tool may result.
Never fire fasteners into air because fasteners may injure operator or others and damage to
tool may result.
The tool is equipped with a fixed block that can change the operating mode from sequent fire
to single fire. When the orientation block is rotated to the sequent fire position, the tool will
sequentially fire. If it is rotated to the single fire position, the tool will fire the fastener singly
only. To fire the next fastener, both the trigger and the safety nose must be released.
Quick
Coupler
Air Hose
Quick
Oiler
Connector
Quick
Coupler
Regulator
Not all components shown are included.
17
Filter
Air
Compressor
www.lowes.com
®

Publicité

Table des Matières
loading

Table des Matières