Blue Hawk SGY-NR-KITC Mode D'emploi page 11

OPERATING INSTRUCTIONS
4. Air supply
When connecting air supply always keep hands and body away from discharge area of tool.
A filter regulator-lubrication (not included) is required and should be located as close to the
tool as possible.
Make sure the air pressure is set at the correct range of 70 - 110 PSI before using. Never
exceed 120 PSI.
4
Quick
Connector
Tool
5. Loading fasteners and operating
Insert a strip of fasteners into magazine, keeping it pointed down.
Release the latch and pusher Slide the pusher against the nails.
Connect the tool to the air supply. Make sure the air pressure is in the correct range.
Test the driving depth in a sample piece of wood before using. If the fasteners are being
driven too far or not far enough, adjust the regulator to provide less air pressure or more air
pressure.
Never operate tool unless safety nose is in contact with workpiece. Do not operate tool
without fasteners or damage to tool may result.
Never fire fasteners into air because fasteners may injure operator or others and damage to
tool may result.
The tool is equipped with a fixed block that can change the operating mode from sequential
fire to single fire. When the orientation block is rotated to the sequential fire position, the tool
will sequentially fire. If it is rotated to the single fire position, the tool will fire the fastener
singly only. To fire the next fastener, both the trigger and the safety nose must be released.
Quick
Coupler
Air Hose
Quick
Oiler
Connector
Quick
Coupler
Regulator
Not all components shown are included.
11
Filter
Air
Compressor
www.lowes.com
®