Hama 00210509 Mode D'emploi page 4

4. Installation
Note
• Before installing the holder, check the installation options in your vehicle. If in doubt, check the
vehicle's instruction manual or contact the vehicle manufacturer.
• Never apply force when using the product or during installation.
4.1 Suction cup holder
• Remove the protective lm from the suction cup.
• Open the locking lever on the suction cup (A).
• Position the holder with the suction cup on a clean, even surface.
(e.g. pane of glass)
• Lightly press the holder onto the required installation surface and close the locking lever to secure
the holder in place.
• After installation, always check that the suction cup is secure.
• To release the suction cup from the installation surface again, open the locking lever. If necessary,
pull gently on the tab to completely release the suction cup.
4.2 Adjusting the angle and tilt
The smartphone holder can be steplessly adjusted in terms of angle and tilt with respect to the observer
using a ball head.
• Always adjust the angle and tilt without the device inserted.
• To adjust, loosen the clamp screw on the ball head.
• Adjust the angle and tilt as required and tighten the clamp screw.
4.3 Inserting / removing the device
Note
• Continually check that the smartphone holder is securely seated and the device is securely held.
• Please only use this smartphone holder for your windscreen.
• When you place the back of your Apple smartphone on the in-car holder,
it attaches automatically thanks to the integrated magnets. (B)
Note - devices
Please note that this product is only suitable for Apple smartphones of the latest generation (12).
5. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
5