User Instruction; Frequently Asked Questions - PNI DK101 Manuel Utilisateur

NOTE: The private PIN associated to a card will be deleted at the same time with the card.
Modify private PINs:
•
- disable: press [1] + [2]
- enable: press [1] + [3]
NOTE: Modify private PIN: exit programming mode the long press [#] (the green LED will light) + present card
+ [old private PIN] (default 0000) + [new private PIN] + [repeat new private PIN]. You will hear 2 confirmation
beeps.
• Door contact alarm:
- disable: press [8] + [0]. You will hear 2 confirmation beeps.
- enable: press [8] + [1]. You will hear 2 confirmation beeps.
NOTE: Enabling this option will cause the keypad to sound when the door is left open or when the door is not
unlocked from the keypad.
Alarm delay time: press [8] + [2] + [TT], TT = time interval in seconds. You will hear 2 confirmation beeps.
•
For example, if the door open time is 3 sec then TT = 03.
NOTE: This function can be used after enabling the door contact.
Exit programming mode: press [#]. You will hear 3 confirmation beeps.
•
Cancel command: press [#]
•
Restore factory default: press [8] + [6]
•
Reset programming PIN: short the J2 jumper to reset programming PIN to factory default.
•

USER INSTRUCTION

Card or PIN door open mode:
- present card or type your private PIN on the keypad
Card + PIN door open mode:
- present card the type your private PIN on the keypad

FREQUENTLY ASKED QUESTIONS

After the lock is opened there are 8 short beeps
The card reading distance is to short or the card
can't be read
After presenting the card there are 3 beeps and the
lock doesn't open
Present an enrolled card does not unlock the door
Can't enter programming mode and a long beep is
heard
After pressing [5] there are 3 beeps
- the keypad needs higher voltage, please check
the power supply
- the electric current is to low, please check the
power supply
- the keypad works only in card+PIN mode
- the keypad is in programming mode
- check if the door contact is in alarm mode. Disable
door contact.
- multiple buttons were pressed before trying to
enter programming mode. Wait a few seconds then
try again
- card memory full
5
EN