Epson WF-2830 Guide Rapide page 3

■
When using TCP/IP, make sure your network's DHCP option is enabled (your router
manufacturer will be able to assist you with this setting).
■
Print a network status sheet from the product's control panel. Load a few sheets of
plain paper in your product. Press
■
WF-2830: Select
press the
■
WF-2850: Select
>
Status Print Status Sheet
■
Remove and reinstall your product software.
Printing a Connection Check Report
You can print a network connection report and check for any error codes and messages to
solve problems you may encounter with network connections.
1. Load a few sheets of plain paper in your product.
2. Press if necessary, and then do one of the following:
■
WF-2830: Select
the start button.
■
WF-2850: Select
Connection Check
3. The connection report prints. Check for any error codes and follow the solutions on
the report.
Below are a few common error codes and solutions. If you do not see your error code listed
here, see the online User's Guide.
Error code E1: Make sure your router, access point, and/or hub are turned on, and the
network cable is securely connected to your device and to your product.
>
Settings Network Settings
start button.
>
Settings General Settings
. Then press the
>
Settings Network Settings
>
Settings General Settings
>
Print Check Report
Message or solution
if necessary, and then do one of the following:
>
Print Status Sheet
>
Network Settings
start button.
>
Connection Check
>
Network Settings
.
Error code
Printing a Connection Check Report
. Then
>
Network
, and press
>
3