Functional Test - Tecsis P3308 Instructions De Service

7. Starting, operation
Specifications
CE- conformitiy

Pressure equipment directive

EMC directive
Wiring protection

Short-circuit proofness

Reverse polarity protection

Overvoltage protection
Weight
{ } Items in curved brackets are optional extras for additional price.
When designing your plant, take into account that the stated values (e.g. burst pressure,
over pressure safety) apply depending on the material, thread and sealing element used.

Functional test

The output signal must be proportional to the pressure. If not, this might point to a
damage of the diaphragm. In that case refer to chapter 9 „Troubleshooting".

Open pressure connections only after the system is without pressure!

Observe the ambient and working conditions outlined in section 7 „Technical
data".

Warning
Please make sure that the pressure sensors is only used within the overload
threshold limit at all times!
When touching the pressure sensors, keep in mind that the surfaces of the
instrument components might get hot during operation.
Caution
Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
Model P3308
97/23/EC
2004/108/EC, EN 61 326 Emission (Group 1, Class B) and
Immunity (industrial locations)
Sig+ towards 0V
UB+ towards 0V
VDC 36
kg Approx. 0.08
GB
21