Cleaning Care - Sinbo SHD 7050 Mode D'emploi

Before First Time Using
Remove the product and accessories carefully from the original packaging. Inspect the
delivery contents for completeness and damages. Should the delivery contents be
incomplete or damaged, contact your sales outlet immediately.
OPERATION
Caution: Before use, check that the mains voltage corresponds to the voltage stated on
the unit.
• Connect the power plug to an appropriate AC outlet.
• Turn on the product using the ON/OFF switch. The power indicator will light up and the
product will heat up to 100 °C within 60 seconds.
Curler
Note:
• Before use, make sure your hair is clean, dry and not tangled.
• Do not use hairspray when using the device.
1. Comb your hair and divide it into strands (1.5 - 2.5 cm).
2. Slide the retaining clip downwards and place a strand of hair into the opening. Release
the retaining clip to secure the strand of hair (Fig. 1).
3. Turn the curling iron so that the hair winds along the spiral around the entire bar. (Fig.
2).
Attention! Only hold the curling iron by the holding tip and the handle.
4. Hold the curling iron in this position for no more than 10 seconds.
5. Open the retaining clip and turn the curling iron so that the hair comes loose. (Fig. 3).
Follow the same procedure on the other strands of hair until the desires overall result
is achieved. In order to enhance the curls, you can repeat the procedure several times.
Allow the hair to cool before styling it again.

CLEANING CARE

• Warning - risk of electric shock! Unplug the product and let it cool down completely
before
cleaning. Never immerse electrical parts of the product in water during cleaning or
Fig. 1 Fig. 2
- 8 -
Fig. 3