After Using - Kiwi KSB-2210 Manuel D'instructions

10. Insert the measuring cup into the opening in the lid.
11. Select a speed by turning the control knob or push one of the quick select buttons
(see section "Control knob").
12. Always switch off the appliance by setting the control knob to "O" before you
open the lid.
Control knob
You can set the control knob to any speed between "0" or "1" or "2" and "P"
"1"--- Lowest speed
"2"--- Highest speed
"P"--- Hand operation speed "0"--- Stop speed
Noted: Do not let the appliance run for more than 1 minute at a time. If you have not
finished processing after 1 minute, switch off the appliance and let it cool down to
room temperature before you let it run again (more than 1 minutes).
Tips
1. Cut meat or solid ingredients into smaller pieces before putting them in the
blender jar.
2. Do not process a large quantity of solid ingredients at the same time. Process
these ingredients in a series of small batches instead.
3. To make tomato juice, cut the tomatoes in four and drop the pieces through the
opening in the rotating blades.

AFTER USING

1. Unplug the appliance
2. Remove the lid with the measuring cup from the blender jar.
3. Remove the blender jar with the unit interface attached from the motor unit. 4.
Unscrew the blade unit interface from the bottom of the blander jar.
5. Always clean the removable parts immediately after use.
CLEANING
We advise you to clean the removable parts immediately after use.
Noted: Avoid touching the blades. The blades are very sharp. All parts except the
motor unit are dishwasher proof. Do not rinse the motor unit the tap. Do not use
abrasive cleaning agents, scourers, alcohol etc. to clean the motor unit.
1. Unplug the appliance.
2. Disassemble all removable parts before cleaning them. Do not forget to remove
the sealing ring from the blade unit.
3. Clean all removable parts in the dishwasher or in warm water with some washing-
up liquid.
4. Clean the motor unit with a moist cloth.
6