Overhead Mounting; Floor Mounting - Chauvet Professional Amhaze ECO Manuel De Référence

Table des Matières

Les langues disponibles

AC Power

This product has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC,

50 Hz, depending on the specific model purchased.

AC Plug

Connection

AC Live

AC Neutral

AC Ground

To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely

disconnect the product from power via breaker or by unplugging it.

Resetting the Breaker

This product is equipped with a resettable circuit breaker. If the breaker trips, all sections of this product will lose power.

Remove the power cord from mains power.

Allow unit to cool for 15 minutes.

After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.

Plug the product's power cord into the power outlet and continue using as recommended.

DMX Linking

The AmHaze ECO will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is available

from

www.chauvetprofessional.com.

DMX Connection

The AmHaze ECO uses a 3- or 5-pin DMX data connection for its 3 DMX personalities. See the User Manual for

information about connecting and configuring the product for DMX operation.

RDM (Remote Device Management)

Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally

along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers

have this capability. The AmHaze ECO supports RDM protocol that allows feedback to make changes to menu map

options. Download the User Manual from

Mounting

Before mounting this product, read the

mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to

http://trusst.com/productcategory/truss-clamps/

Product Mounting Diagram