Extremis Sol+Luna Australis Instructions De Montage page 12

English
ASSEMBLY
A
Australis
1. Lay the frame with the batyline fabric on trestles.
2. Position the legs on the outside of the frame.
3. Attach the left and right foot to the frame with 4
pre-coated M6x12 bolts each.
4. Sol+Luna has 5 positions.
B
Mattress
1. Position the mattress on the lounger and attach
it to the batyline with the loops on the underside
of the mattress. Note that the loop closest to the
middle needs needs to be at the head end.
C
Bolster pillow + counterweight
1. Start by putting the bolster pillow through one
loop of the weight.
2. Now put it through the second loop, ensuring that
it is centrally positioned.
3. Now lay the whole thing over the headrest as
shown in the diagram. You can adjust the height
by hanging the weight higher of lower.
D
Tapa table
1. Attach the tabletop to the table support with 3
pre-coated M6x12 bolts.
2. Now insert it into one of the four holes in the
lounger.
E
Linking table
1. Attacht the tabletop to the 2 table supports with 3
pre-coated M6x12 bolts on each side.
2. Now insert it into one of the four holes in the
lounger.
MAINTENANCE
Batyline fabric
Clean with lukewarm water and a gentle detergent.
Tips for stubborn stains or mould:
1. Clean with water and "Cleaner 500":
en.sergeferrari.com/corporate-en/cleaner-500
2. Spray "Cleaner 500" onto the batyline and allow it
to soak in for 2-3 minutes.
12
3. Rub the surface repeatedly with a soft brush using
a circular motion.
4. Then rinse with plenty of water to prevent any
remaining dirt from drying into the fabric.
5. Finally, wipe carefully with a dry cloth.
Never use abrasive substances or solvents!
Powder-coated parts
Clean with lukewarm water and a gentle detergent.
Sunbrella fabric
Daily maintenance:
1. Shake or brush off loose dirt immediately.
2. Make a mixture of 15 ml gentle detergent per litre
of lukewarm water (max 40°C).
3. Use a sponge or soft brush.
4. Let the suds soak in for a moment.
5. Rinse thoroughly to remove all soap residue.
6. Simply allow to dry. Sunbrella dries very quickly.
It is also possible to wash the cushion cover in
a washing machine (max 40°C). Never put the
cushion covers in the tumble drier!
Creases can be ironed out if desired. Always set
your iron to the synthetic fabric settings to do this.
Test a small, inconspicuous area of the fabric before
ironing it all over. NEVER use steam.
Tips for stubborn stains or mould:
1. Make a mixture of 60 ml bleach and 15 ml gentle
detergent per litre of lukewarm water. TIP: protect
the surroundings where you are cleaning. The
bleach can affect the colour of other, non-Sunbrel-
la fabrics and can have a harmful effect on nature
and the environment. So we advise you not to use
it near water or natural surroundings that could be
damaged by the bleach.
2. Spray the suds onto the entire Sunbrella item and
let it soak in for 15 minutes.
3. Remove stains with a sponge of soft brush.
4. Rinse thoroughly to remove all soap residue.
Simply allow to dry.
For more information about caring for your Sunbrel-
la fabrics, see www.sunbrella.com
HPL tabletop
High Pressure Laminate, to be cleaned with standard
detergents such as those you use in the kitchen. For
stubborn dirt, we use "HG plastic, paint and wallp-
aper intensive cleaner". More info: www.hginternati-
onal.com