Whale Expanse WW0821U Consignes D'installation Et D'utilisation page 14

Step 4 Attaching the Flue Terminal to the Vehicle
A wooden spacer may be required to locate the flue terminal below the side valence. Attach the flue terminal with 2 x
No.8 x ¾" pozi screws (not supplied). The flue terminal must be at the side of the vehicle, where an awning will
never be fitted to.
Please note: The flue duct from the Water Heater to the terminal must have a maximum of one rise. As shown by
point A in Fig. 25. This allows condensation to drain away from the Water Heater.
Please note: When installing flues, sharp bends must be avoided and the number of bends must be minimised.
The flue must be attached to the underside of the vehicle floor with the two brackets supplied. Clip the bracket
around the flue and use two screws (No.8 x ¾") to secure each bracket to the underside of the vehicle floor as per
Fig. 26.
A flue may be shortened to a minimum length of 0.75m, but must not be cut any shorter than this. Flues must not
be lengthened.
INSTALLATION INSTRUCTIONS - ONBOARD MODELS
Whale Part Number: WW0821O (Suffix: B or R or C)
Wooden
Spacer
Fig. 24 Attaching the Flue Terminal to the Vehicle
Water Heater
Fig. 25 Flue Direction
Fig. 26 Attaching Flue Bracket
Side Valence
Screws
Flue
Flue
A
Bracket
Flue
14