Specification; Features; Operation; Prepare The Tool - HDX HDX50LSLWN Guide D'utilisation Et D'entretien

Specifications
Air inlet: 1/4 inch NPT
Magazine capacity:
L Cleats: 100pcs, Staples: 90pcs
Weight: 8 8 lbs .
Maximum pressure: 115 psi
Pressure range: 70 psi – 115 psi
Pin size range: 1-1/2 inch to 2 inch
7.2mm (9/32")
12.7mm (1/2")
"
38 mm 1-1/2 38 mm
"
45 mm 1-3/4 45 mm
"
50 mm 2 50 mm
(16Ga. L Cleats) (15.5 Ga. Staples)
Compatible With Generic Brands of 15.5 Gauge Staples & 16
Gauge L-Cleats.

Features

Revolutionary 2 in 1 design
For use with Staples, L-Cleats.
Non-marring design
Provides increased protection from marring when
working with a finished flooring surface.
Durable construction
Light weight and durably constructed of high-strength
aluminum and heat treated steel parts.
Mallet included
"
1-1/2
"
1-3/4
"
2
8

Operation

1

Prepare the tool

The tool is shipped with the arm (A) part detached from the
Main body part.
Follow these instructions to prepare the tool for using.
Set the arm (A) against the Handle .
Wrench-tighten the nuts (B) until the arm (A) and Handle
(C) are secured and the arm (A) is locked against Handle
(C).
Arm (A)
Hex. Bolt
Nut (B) Handle (C)
Prepared
Flooring Nailer
WARNING: If any parts are missing, do not operate this
tool until the missing parts are replaced. Before using
this tool, make sure the arm part and the main body
part are screwed together tightly. Failure to do so
could result in possible serious personal injury.
2

Loading L cleat nails

Connect the tool to the air source.
Press down on the latch button (F). Pull the magazine
cover (D) back to the end of the magazine.
Place full clip of desired fasteners into magazine from the
side. Up to 100 cleat nails can be loaded into magazine.
Be noted that, when loading the L cleat nails, the side
with the L head should be in the left of the magazine
pusher (E).
Push the magazine cover (D) forward until magazine
pusher (E) pops up.
Latch button(F)
L Cleat head
direction
Magazine
pusher
(E)
3

Loading staples

Connect the tool to the air supply.
Press down the latch button (F), the pull the magazine
cover (D) back to the end of the magazine.
Place a full clip of 1/2 in. crown staples in the magazine
from the top. Up to 90 staples can be loaded into
magazine.
Push the magazine cover (D) forward until the magazine
pusher (E) pops up.
Latch button (F)
Load staples
from the top
Magazine cover
Magazine
pusher
(E)
HOMEDEPOT.COM
9
Please contact 1-800-514-6729 for further assistance.
Magazine
cover
(D)
(D)