ALPATEC DH 10 M Notice D'utilisation page 16

All manuals and user guides at all-guides.com
notice DH_10 M:notice DH_25EC 21/12/07 10:36 Page 16
OPERATION INTRUCTION
1. Put the humidity control switch on ARRÊT position.
2. Install permanent drainage (if needed).
3. Plug the product.
4. Turn the humidity control switch clockwise.
The humidity rate can be adjusted from 20 to 80%, the middle position is for 60%.
MAX position means that the product will keep on dehumidifying.
5. When the water tank is full, the corresponding LED is ON and the product stops working.
6. Remove the tank, empty and replace it.
The product starts again.
If the product does not restart, control the tank position.
7. To stop the product, turn the humidity control switch in ARRÊT position.
When the product is stopped, wait for 3 minutes before restarting it (compressor protection).
NOTE: for a better dehumidifying effect, keep clear the areas in front and rear of the product.
16