Working Advice; Troubleshooting - Honda HHT36AXB Manuel Du Propriétaire

Working Advice

Should the cutting blade jam in long or dense grass, simply release then re-engage the switches.
This will activate the auto-release function that releases the jam by quickly reversing the motor for a short time.
For optimum performance and finish always use correct cutting accessory as shown below.
Cutting system

Troubleshooting

d.c.
Problem
Blade guard can not be
mounted over cutting
blade
Machine fails to operate
Machine runs
intermittently
Machine does not cut
Increased vibration
Usage application area
Grass
2,0 mm line
2,7 mm line
3,0 mm line
Possible Cause
Incorrect assembly
Battery discharged
Battery too hot/cold
Motor protector has activated
Internal wiring of machine
damaged
On/Off switch defective
External cabling damaged
Cutting blade damaged
Cutting blade damaged
Cutting line broken
Debris build up on cutting head
Blade nut loose
Light vegetation
Corrective Action
Remove cutting blade and mount blade guard first
Recharge battery
Allow to cool/warm
Allow motor/electronics to cool for 5 minutes and cut
in stages
Contact authorised service dealer
Contact authorised service dealer
Contact authorised service dealer
Replace the blade (always wear protective gloves).
Ensure blade is not upside-down (8T and saw blades).
Replace the blade (always wear protective gloves)
Replace line (see figure 7 of illustrations)
Clean slip plate groove
Tighten nut bolt to 20 Nm ensuring the blade, nut
shield and dome washer are all present and central
(always wear protective gloves) (see figure 5 of
illustrations)
English | 7
Heavy vegetation