Front Panel; Rear Panel - Ibiza sound MM-PLAYER Manuel D'utilisation

FRONT PANEL

1. ON/OFF: on/off switch
2. 6.3mm headphone jack
3. INPUT 1: Line level AUX input via 3.5mm jack
4. MIC: XLR/6.3mm combo input connector for a dynamic balanced microphone
5. MIC LEVEL: Volume control of the mic input
6. TONE: Rotary control for the bass, medium and high frequencies
7. BALANCE: Sends the stereo signal into the left or right channel
8. MASTER: general volume control
9. SD: Connection port for SD memory cards
10. Connection port for USB storage devices
11. Infrared receiver of the remote control
12. Display
13. Input selector switch: Select the input signal that you want to send to the OUTPUT. If you select the option
USB/SD/FM/BT/INPUT1 and use both the USB/SD/MP3 player (or the FM tuner) and INPUT1, the sound
will be mixed by the OUTPUT connector. This selector switch also allows you to select which input will be
recorded on the USB storage device or SD memory card when the RECORD function is used.
14. USB/SD/MP3 player buttons, FM tuner and built-in Bluetooth receiver.
A) MODE: Press this button successively to cycle through the USB storage device, SD memory card, FM
radio tuner, Bluetooth receiver and recording option (RECORD)
B) Allows you to start or pause playback. In FM mode: Performs an automatic tuning of the FM radio
stations. The tuning will start from the lowest frequency and the stations will be saved automatically in
consecutive memory positions. If you want to stop tuning, press this button again. In RECORD mode, press
to start and stop a recording.
C) A short press on these buttons allows you to move to the previous or next song. A long press on these
button starts a fast rewind or fast forward search through the current title.
In FM mode: A short press allows you to move to the previous or next tuned station.
D) REPEAT: Allows you to select a playback mode between the following: repeat all (ALL), normal playback
(NORMAL), repeat a track continuously (SINGLE), repeat folders (FOLDER), random play (RANDOM) and
play the first 10 seconds of each track (BROWEE).
15. TAPE/MONITOR: Sends the TAPE IN input to the TAPE OUT output. Press this button if you want the input
connected to the TAPE IN connectors to play through the tape out.
16. LED indicator: Lights up when the TAPE/MONITOR button is activated.

REAR PANEL

1. BT: Bluetooth reception antenna
2. AUX1/AUX2/AUX3 : 2x RCA connectors for phono, tuner & AUX devices
3. INPUT 1: Line level input via RCA connectors
4. TAPE IN: Line level input via 2x RCA connectors
5. TAPE OUT: Line level output via 2x RCA connectors. This output will play the audio of the device connected
to TAPE IN if the TAPE/MONITOR button on the front panel is pressed.
6. OUTPUT1-2: Line level outputs via 2x RCA connectors
7. OUTPUT: Balanced line level stereo output via 2x XLR connectors
8. GND/LIFT: This selector is normally placed in the GND position. If the installation has ground noise, place
the selector in the LIFT position to disconnect the ground and earth from the device.
9. FM: input connector for the FM antenna
10. Power input 230/115V~
11. Power voltage selector
Battery Warning for the remote control
This symbol indicates that used batteries should not be disposed of with household waste but deposited in separate
collection points for recycling
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING
Do not swallow the battery. Danger of chemical burns. The supplied remote control of this product contains a button cell. In
case of ingestion, it might cause serious internal burns within only 2 hours that might lead to death.
Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
4
MANUAL - MM-PLAYER
© Copyright LOTRONIC 2019