Safety Instructions; Technical Data - Hard Head 017285 Mode D'emploi

EN

SAFETY INSTRUCTIONS

• The maximum spot load is 256 kg per
shelf.
• The weight must be evenly distributed on
the shelves.
• Make sure not to exceed the maximum
spot load per shelf, or for the whole unit.
• Do not place the unit in a room that is
very humid because this could damage
the shelves.
• Wear safety gloves when assembling the
unit.
• Anchor the unit with a suitable wall
bracket.
NOTE:
Make sure not to drill into water pipes or
electric cables.
SYMBOLS
Read the instructions.
Approved in accordance
with the relevant directives.

TECHNICAL DATA

Height
Width
Depth
Max weight per shelf
DESCRIPTION
• Stable storage shelf unit designed for use
in a corner.
• Made of heavy-duty zinc-plated sheet
metal, with five extra steel reinforced
shelves made of MDF.
10
ASSEMBLY
BEFORE ASSEMBLY
•
FIG. 1
•
•
•
•
•
ASSEMBLY
1.
FIG. 2.
2.
FIG. 3
3.
1800 mm
900 mm
900 mm
4.
265 kg
5.
FIG. 4
L
Remove all the packaging material and
check that all the parts are included.
Check the product for transport damage
before assembling.
Assemble the product on a clean and level
surface (e.g. carpet) to avoid damage.
Use a rubber mallet to avoid damaging the
material.
Place the unit on a level surface. Otherwise
this will compromise safety, or the
maximum supporting capacity.
Only use plugs and screws suitable for the
type of wall and weight of the shelves.
Plugs, screws and tools for wall mounting
sold separately.
Assemble the first shelf support as shown
in in figure.
Assemble the second and third shelf
support in the same way.
Continue with the fourth and fifth shelf
support by using parts 7 and 8 as shown
in figure.
Place the shelves (9) on each level.
Fit the plastic feet (10 and 11).