Assembly - Little Wonder HPV Manuel Technique

ASSEMBLY

ASSEMBLY
1. Attach the collector assembly to the base unit:
• Bolt the collector assembly to the frame with
4 sets of bolts, washer, and nuts
• Slide the rectangular end of the collector
over the housing and mount the flange with 2
sets of washers and nuts
2. Attach the throttle control cable to the handle
on the collector assembly:
• Bolt throttle control lever to handle with
washer and nut
• Secure throttle cable to handle with cable
ties in 2 places
3. Install the band clamp into the debris bag (wear
gloves when handling band clamp):
• Slide the bracket end of the band clamp
through the left side opening of the sleeve on
the debris bag until it emerges from the right
side
• Feed the tail end of the band (on the clasp
side) behind the bracket in the sleeve
• Pinch the wire form on the clasp together and
connect it through 2 holes in the adjustment
bracket such that it will close tightly over the
collector
4. Connect the debris bag by placing it over the
bottom lip of the collector and closing the clasp
to secure the bag. Adjust the clasp wire form to
the appropriate hole position on the bracket to
insure a tight fit. If the bag will not fit tight within
the range of the 3 adjustment holes, insert the
bag seal strap:
• Unhook the wire form from the bracket
• Pull the tail end of the band back out from
behind the bracket
• Feed one end of the seal strap behind the
metal band and through the channel to the
other side
• Tuck the other end of the seal strap behind
the bracket (overlapping the lead end of the
seal strap)
• Feed the tail end of the band clamp behind
the bracket (overlap the seal strap)
• Connect the wire form to the appropriate
holes in the bracket and secure the debris
bag to the collector
8
5. Attach nozzle assembly to base unit:
• Attach one end of the hose to the nozzle
assembly with the bridge clamp Assembly
• Slide the other end of the hose over the
edge of the inlet on the front plate
• Hook one side of the nozzle bracket over
the front axle
• Bend the other end of the nozzle bracket
inward to hook it over the axle and engage
the pins on the wheel bracket with the slots
on the nozzle bracket
• Secure the hose to front plate inlet with the
bridge clamp
• Attach the nozzle cable end fitting through
the hole in the nozzle bracket
6. To remove nozzle assembly (for purposes of
storage, or clearing blockages):
• Turn engine off and disconnect spark plug
• Loosen hose clamp on the front plate with
flathead screwdriver or 5/16 wrench
• Slide hose off of front plate inlet
• Bend one side of nozzle bracket inward and
twist the assembly to remove the hook from
the axle
• Twist back and lift to remove the other side of
nozzle bracket from the axle
NEVER RUN OR OPERATE YOUR MACHINE
UNLESS DISCHARGE BAG IS ATTACHED,
AND THE INTAKE NOZZLE IS INSTALLED.
LITTLE
WONDER
HPV