Juniper Networks NETSCREEN-5GT ADSL Guide De L'utilisateur page 29

Using the Reset Pinhole
You can reset the device and restore the factory default settings by pressing the reset
pinhole. To perform this operation, you need to either view the device status LEDs on the
front panel or have a Console session as described in
page 13.
1. Locate the reset pinhole on the rear panel. Using a thin, firm wire (such as a
paper clip), push the pinhole for four to six seconds and then release.
The Status LED blinks amber. A message on the Console states that erasure of the
configuration has started and the system sends an SNMP/SYSLOG alert.
2. Wait for one to two seconds.
After the first reset, the power LED blinks green; the device is now waiting for the
second reset. The Console message now states that the device is waiting for a second
confirmation.
3. Push the reset pinhole again for four to six seconds.
The Status LED lights amber for one-half second, and then returns to the blinking
green state.
4. The device resets to its original factory settings.
When the device resets, the Status LED turns amber for one-half second and then
returns to the blinking green state. The Console message states that the configuration
is erased and the unit is reset. The system generates SNMP and SYSLOG alerts to
configured SYSLOG or SNMP trap hosts.
5. The device restarts.
If you do not follow the complete sequence, the reset process cancels without any
configuration change and the console message states that the erasure of the configuration
is aborted. The Status LED returns to blinking green. If the device did not reset, an
SNMP alert is sent to confirm the failure.
NetScreen-5GT ADSL
Resetting the Device to Factory Defaults
"Using a Console Connection" on
Reset Pinhole
25