Parts Identification - Dri-Eaz Studebaker AirPath Manuel Du Propriétaire

PARTS IDENTIFICATION

Wheels
Inlet Grill
AirPath T
Power
Cord
AirPath U
(Shown, below)
Rotomolded
Shell
Handle
High (II) / Low (I)
Switch
V
OP IEW
Outlet
Grill
Locking Caster
Lock Washer
Flat Washer
V
NDERSIDE IEW
OPERATING INSTRUCTIONS
Setting Up
1. Wheel casters are in a separate bag. Flip unit over so the
bottom faces up. Take casters out of bag and screw
casters (with flat washer then lock washer and then
caster) into the leg openings on the bottom of the housing.
2. Keep the air inlet and outlet grills clean and free of debris.
With the unit unplugged and turned off, look inside the fan
for any debris that has fallen in the fan chamber; carefully
dislodge debris if present.
3. Unwrap the cord and plug the unit into a standard 115V
outlet. Caution! Be sure the unit is turned off before
plugging in.
Getting Started
1. To dry carpet, position the AirPath in the center of a
12 × 12 ft. section to be dried.
2. Set the switch at the desired speed. Setting I is for low
speed and setting II is for high speed. Allow 15–20 minutes
of drying time per section. If the room is larger than
12 × 12 ft. then move the unit to the center of the next
12 × 12 ft. section of room for drying (see Drying Tips for
instructions).
3. Check for proper operation before leaving the unit
unattended. Do not move or carry the AirPath when it is
running. CAUTION! Do not lift the AirPath while the unit is
turned on, as it could result in injury.
Drying Tips
1. After drying first 12 × 12 ft. section turn off the unit.
2. Unplug unit if the cord does not reach length of next
placement.
3. Pick up or roll the unit using the handle and move it to the
center of the next area (12 × 12 ft. area) of carpet for
drying. NOTICE! Do not use the electrical cord to move or
position the unit. Turn the unit to the desired speed (Low – I
or High – II).
Transporting and Storing
1. Use the handle to load or carry the unit.
2. When transporting in a vehicle, secure the unit and strap it
into place to prevent sliding and possible injury to the unit
and vehicle occupants. NOTICE! Store securely to avoid
any damaging impact to the motor, blades, and other
internal parts.